Inficon Maxtek PM-700 Plating Monitor Manual de usuario descargar pdf (Pagina 62)

PM-700 SERIES PLATING MONITOR

4.8.4.3.2 Restore Parameter Store (Instruction 20h)

This operation inputs the entire parameter store from the host computer to the

plating monitor and then stores these values in their respective memory locations.

To initiate this operation, the computer would output the following data stream:

Header

(2 bytes)

Instruction Code

(1 byte)

Message

Length

(1 byte)

Command

Code or

Message

Checksum

(1 byte)

FFh FEh 20h 47h 71 bytes checksum

4.8.4.3.3 Remotely Activate (Instruction 30h)

This operation allows the computer to perform a remote key press of the plating

monitor's front panel buttons through the RS232. The valid key codes are as

follows:

Table 9 Remote Activation Command Codes

Remote Activation

Command Code

Description

1h Set DAC outputs to zero scale

2h Set DAC outputs to full scale

4h Manual probe swap *

8h Stop button

10h Deplate button

20h Preplate button

40h Plate button

* This parameter is only available in the dual probe models.

The data stream format to initiate a remote activation command is as follows:

Header

(2 bytes)

Instruction Code

(1 byte)

Message

Length

(1 byte)

Command Code

or Message

Checksum

(1 byte)

FFh FEh 30h 1h 1 byte checksum

For example, to initiate a remote plate start, the computer would send:

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 82 83

Comentarios a estos manuales

Sin comentarios

Inficon Maxtek PM-700 Plating Monitor Manual de usuario Pagina 62

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Inficon Maxtek PM-700 Plating Monitor